Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • xingshou

    I am using Tunnelblick, Mac OS X OpenVPN client.
    I enabled DHCP server, but Tunnelblick does not still get an IP address from ZeroShell. But if I give static IP address range, it works as expected.

    I attach a log in Tunnelblick below.

    Sat 05/10/08 11:26 AM: WARNING: No server certificate verification method has been enabled. See for more info.
    Sat 05/10/08 11:26 AM: LZO compression initialized
    Sat 05/10/08 11:26 AM: Control Channel MTU parms [ L:1576 D:140 EF:40 EB:0 ET:0 EL:0 ]
    Sat 05/10/08 11:26 AM: Data Channel MTU parms [ L:1576 D:1450 EF:44 EB:135 ET:32 EL:0 AF:3/1 ]
    Sat 05/10/08 11:26 AM: Local Options hash (VER=V4): ’31fdf004′
    Sat 05/10/08 11:26 AM: Expected Remote Options hash (VER=V4): ‘3e6d1056’
    Sat 05/10/08 11:26 AM: Attempting to establish TCP connection with
    Sat 05/10/08 11:26 AM: TCP connection established with
    Sat 05/10/08 11:26 AM: TCPv4_CLIENT link local: [undef]
    Sat 05/10/08 11:26 AM: TCPv4_CLIENT link remote:
    Sat 05/10/08 11:26 AM: TLS: Initial packet from
    Sat 05/10/08 11:26 AM: VERIFY OK: depth=1
    Sat 05/10/08 11:26 AM: VERIFY OK: depth=0
    Sat 05/10/08 11:26 AM: Connection reset
    Sat 05/10/08 11:26 AM: TCP/UDP: Closing socket
    Sat 05/10/08 11:26 AM: SIGUSR1[soft


    Thanks jeremy!

    I am sorry I need to reconfigure ZeroShell to reply your answer!

    I just hope something like below to be added in the ZeroShell. It was taken from one of the administrator screen in NETGEAR SSL312 VPN gateway. It’s user interface is very easy to understand.

    Sungsoo Kim

    VPN Tunnel Client

    Client IP Address Range
    Client Address Range Begin :
    Client Address Range End :

    Enable Full Tunnel Support : [ ]

    Note: Static routes should be added to reach any secure network in split tunnel mode.

    [Apply] [Cancel]

    Add Routes for VPN Tunnel Clients

    Destination Network : [_______________]
    Subnet Mask : [_______________]

    [Add Route] [Cancel]

    Configured Client Routes

    Destination Network Subnet Mask [Delete]


    After removing all the items in “Client IP Address Assignment” section and setting up DHCP, my VPN client is sending all the traffic to VPN gateway.

    I want to avoid all the traffice from being sent to the VPN gateway regardless of their destination. Therefore I hope ZeroShell improve this problem so that we can determine whether the VPN gateway is to be used as a default gateway in client-side or not.

    Sungsoo Kim

Viewing 3 posts - 1 through 3 (of 3 total)