[Madwin]

I’m wondering if the DEFAULT class is for ALL traffic, or if i can narrow it to a class, since this is kinda like an ISP implementation with several speed plans (ex. 1024K, 512K, 256K, etc) but to no avail, it all goes through DEFAULT 🙁

i’ve tried everything on the Zeroshell but no luck 🙁

[Madwin]

I already searched the forums to see if there a post that can help me, but all the posts i found are doing a QoS with a Bridge, and i need it on Router mode, and according to my config, it’s all good except that all traffic goes through the DEFAULT class, i really really appreciate the help on this

[Madwin]

fulvio, i tested again the command for the Full Duplex and it works, but i want to know if there is a way I can set it up so it can start at Full Duplex once the server reboots.

Best Regards

[Madwin]

Thanks for the response fulvio

one other thing, in the Setup–>Network Menu, both my interfaces are Half Duplex, is there a way i can set them up to Full Duplex through the web interface or the linux shell? I tried doing it like this:

ethtool -s ETH00 autoneg off duplex full

but it didn’t work, is there a way i can do it?

Best Regards

[Author]

Posts