Gandalf

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: ZS, VDSL and MTU #52809
    Gandalf
    Member

    I am a liitle bit disappointed 🙁 that nobody would or could answer to my question!!
    Is there really no one around who has the same issue and solved it??

    Gandalf…..

    in reply to: about half speed with zs #52539
    Gandalf
    Member

    this seems to be the same issue I have with vdsl. the ppp0 mtu rate seems to be lower than rated. if you do an ip link show at the shell you’ll see that mtu for ppp0 should be set to 1492. BUT if you go to http://www.speedguide.negt and let check from the outside you’ll get 1452 which seems to be is too low to handle unfragmented packets fast enough.
    I have nothing found on this issue nowhere. And the programmers don’t say a word to this.
    Hopefulle they get this issue managed

    G

    in reply to: Alix 2d3 max bandwith #52460
    Gandalf
    Member

    Hello Heppe,
    I am using same Alix Board with ZS and Telekom VDSL 50. My actual DL Speed ist around 22MB- When I am using monowall I will get the 50MB DL Speed-you see the Alix board is able to manage the spee.
    Hope that helps-.

    GtG

Viewing 3 posts - 1 through 3 (of 3 total)