Bibelo

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • in reply to: radius attributes #52595
    Bibelo
    Member

    It works wonderfully thank you very much again!!! 😀

    Now I’ve got to change a little bit the way ZS starts, because I wanted a LiveCD + config on a USB Key or hard drive, but I guess I’ll just copy the folder in one partition on the hard drive and try to mount it at startup (as you detailled).

    in reply to: radius attributes #52594
    Bibelo
    Member

    Wow thank you very much for your answer, very complete. It’s incredible that you remember well all these details. I’m gonna try that right after buying an ice-cream and post a feedback here.

    in reply to: radius attributes #52592
    Bibelo
    Member

    So I wonder (and I assume) that this is why my Cisco switch does not accept the port, even though the authentication is valid.

    On the Cisco cli, I receive this message :
    “Invalide attribute 64 ignored – tag should be 0 aggregated (1)
    MAC XX was rejected on port XX because Radius accept message does not contain VLAN ID, aggregated (1)”

    So I feel the presence of this tag prevents the SW for reading the VLAN ID… ?

    Or Am I going in the wrong direction when trying to solve this tag problem and should look elsewhere?

    in reply to: radius attributes #52591
    Bibelo
    Member

    I confirm that I have the same behavior. I’m looking to find a way to force ZS to use tag 0 instead. I don’t know what to do.

    I see that the version of radiusd on the lastest of ZS (2.0.RC2) is FreeRadius 2.1.10 built in dec 2010.

Viewing 4 posts - 1 through 4 (of 4 total)