7andY

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 5, 2009 at 1:21 pm in reply to: Zeroconf behind proxy but still using captive portal? #46430

    7andY
    Member

    Dont forget that your configuration will disappear when you reboot unless you take steps to reload it as starts up.

    Found this out the hard way…

    November 5, 2009 at 1:17 pm in reply to: How to configure the network cards? #48987

    7andY
    Member

    As there are visitors of many nationalities on here, can I suggest that you do not use shortened versions of English words (‘u’ and ‘ur’ etc). It will make reading a lot easier for all concerned.
    Cheers, 7&Y

    August 4, 2009 at 1:55 pm in reply to: Restricting traffic #48559

    7andY
    Member

    Nice idea, but if I disallow access to my LAN, how are the users to get to my internal DNS servers? 🙄
    Solved it by setting the Captive Portal to not capture traffic destined for my LAN, and setting some Firewall rules to block that access 😆

    Cheers, Andy E.

    July 13, 2009 at 8:02 am in reply to: Parent proxy #48396

    7andY
    Member

    Talking to myself again…

    Using the method in http://www.zeroshell.net/eng/forum/viewtopic.php?t=807, my havp.config settings now survive a reboot!

    July 10, 2009 at 7:35 am in reply to: Captive portal… #48392

    7andY
    Member

    FIXED: I have enabled HTTP Proxy, with a 0.0.0.0/0 destination.

    July 6, 2009 at 2:54 pm in reply to: Captive Portal Issue #48127

    7andY
    Member

    I got to exactly this same point, with exactly the same result.

    It seems you will also need to set up NAT. In the ‘ROUTER’ section click on ‘NAT’. As your setup has the local side on ETH01, highlight ETH00 on the left side, and click on >>> to move it to the right.

    Should sort it for you – did for me!

    Cheers, Andy E.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)