Wifi not visible

Home Page Forums Network Management ZeroShell Wifi not visible

This topic contains 1 reply, has 0 voices, and was last updated by  jrossbach 5 years, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #43958

    jrossbach
    Member

    Dear all,

    i have a AMD APU1C4 board with AR9580 wireless network adapter

      04:00.0 Network controller: Qualcomm Atheros AR9580 Wireless Network Adapter (rev 01)
      Subsystem: Unknown device 19b6:d016
      Flags: bus master, fast devsel, latency 0, IRQ 19
      Memory at f7e00000 (64-bit, non-prefetchable) [size=128K]
      Expansion ROM at e0000000 [disabled] [size=64K]
      Capabilities: [40] Power Management version 3
      Capabilities: [50] Message Signalled Interrupts: 64bit+ Queue=0/2 Enable-
      Capabilities: [70] #10 [0002]

    The card seems is recognized, as it is shown at the wifi manager:

      Starting WiFi subsystem …
      –> Reloading Wi-Fi Kernel module (ath9k) …
      Creating virtual WiFi interfaces:
      WLAN00(wlan0) (Mode:ap Sec:wpa-psk SSID:SatLink Status:up)
      WLAN00: 192.168.1.75/255.255.255.0

      REGULATORY DOMAIN: US (UNITED STATES)

      [wlan0] Qualcomm Atheros AR9580 Wireless Network Adapter (rev 01)
      — If — Mode — SSID


      Hide — WDS — Security –
      >> WLAN00 AP SatLink no no WPA-PSK

    As well, channel scanning is working:

      Using device wlan0(wlan0) for channel scanning …

      1 WiFi channel(s) found.

      Frequency:2.437 GHz (Channel 6)


      wlan0 Scan completed :
      Cell 01 – Address: 4C:B1:6C:14:FC:83
      Channel:6
      Frequency:2.437 GHz (Channel 6)
      Quality=36/70 Signal level=-74 dBm
      Encryption key:off
      ESSID:”WirelessNet”
      Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
      9 Mb/s; 12 Mb/s; 18 Mb/s
      Bit Rates:24 Mb/s; 36 Mb/s; 48 Mb/s; 54 Mb/s
      Mode:Master
      Extra:tsf=0000001567b96180
      Extra: Last beacon: 268ms ago
      IE: Unknown: 000B576972656C6573734E6574
      IE: Unknown: 010882848B960C121824
      IE: Unknown: 030106

    —- 8< ---- CUT But no client is able to connect nor see the wlan access point. Does someone have an idea how to track or check this issue? Best regards Rossi

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.