VLAN not working, broken in release 1.0 beta 16? Home Page › Forums › Network Management › Networking › VLAN not working, broken in release 1.0 beta 16? This topic contains 0 replies, has 0 voices, and was last updated by FlashEngineer 5 years, 3 months ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts March 14, 2014 at 6:36 pm #43884 FlashEngineerMember I’m using still release 1.0 beta 16, and before swapping over to the 3.0, I was just messing around with VLAN but I can’t get it to work. Can anyone help? I just defined a vlan ID 10 on ETH00, and my netgear switch I setup 2 ports on that vlan 10, one connects to my laptop, other to zeroshell. Port to laptop only tags when entering, port to zeroshell doesn’t untag when exiting. I can’t get DHCP on my laptop to the VLAN subnet, (Yes it’s on) March 14, 2014 at 7:08 pm #53217 redfiveParticipant I haven’t knowledge on netgear switch , but the switchport which is connected to Zs must be a trunk port , while the switchport where your pc will be hooked up, is (already and correctly) an access port for vlan 10. Regards Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.