Traffic Shaping fails when netbalancer is active

Home Page Forums Network Management Signal a BUG Traffic Shaping fails when netbalancer is active

This topic contains 1 reply, has 0 voices, and was last updated by  binomix 10 years, 6 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #41393

    binomix
    Member

    Hi,

    I’m running Release 1.0.beta11. This is my configuration:

    ETH00 : LAN
    ETH01: WAN1
    ETH02: WAN2

    (Routed model)

    I’ve activated QoS Rules on Network->QoS->Classifier.

    Packets match correctly when I only have one default gateway (on WAN1 or on WAN2), but when I use the netbalancer using both gateways (WAN1 and WAN2) all the traffic gets classified as DEFAULT.

    Is there a functional incompatibility between QoS and netbalancer in this model ?

    Grazie mille !

    David.

    #47374

    imported_fulvio
    Participant

    I know this issue and at the moment I am not able to find a solution. This is because either QoS or the Internet load balancing use the netfilter mangle table to mark the packets in the IP stack.
    I hope to find a solution to this incompatibility in the near future.

    Regards
    Fulvio

    #47375

    binomix
    Member

    Ok, thank’s for your fast answer.

    Regarding your confirmation on these symptoms, let’s apply one easy solution meanwhile a new release figures out this problem:

    One Zeroshell Box applying QoS and after that one more ZeroShell Box applying the load balancing 😉

    So:

    LAN -> QoS ZeroShellBox1 -> NetBalancer ZeroShellBox2 -> WAN1 | WAN2

    David.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.