system design

Home Page Forums Network Management ZeroShell system design

This topic contains 0 replies, has 0 voices, and was last updated by  m4him 12 years, 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #40617

    m4him
    Member

    I would like to use your product as below. I have 5 public IP addresses, one is the gateway assigned to the Satellite Modem

    Internet
    Satellite Modem (public IP xxx.xxx.xxx.xxx/255.255.255.248)
    Zeroshell packet shaping
    eth0: 192.168.3.0/24
    eth1: public ip
    Aserisk PBX running NAT 192.168.3.3
    Many other machines in the 3.0 subnet

    Asterisk PBX does not like being behind a NAT server so I find it difficult to use Zeroshell as a nat server.
    If Zeroshell provided a sip proxy that would be of great help.

    The ideal solution would be to run Zeroshell on the Asterisk PBX

    What suggestion would you have for this system design?

    #45338

    imported_fulvio
    Participant

    I think you could use a Virtual Server configuration to forward the traffic to the PBX.
    From the section [Router]->[Virtual Server] you can create the port forwardings. In any case, I don’t know how many and what ports you have to forward to make your PBX to work.

    Regards
    Fulvio

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.