Running a command on ifup?

Home Page Forums Network Management Networking Running a command on ifup?

  • This topic has 3 voices and 2 replies.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #44766


    I would like to run a command when PPP0 comes up.. Is this possible?
    In linux you would have the /networking/interface/ifup-script or similar file that would run each time the interface changed.

    Can the same be set up in ZeroShell?

    Thank you.


    There are a few forums or messages, lots of data available for your information, but you write so well that any undergraduate can easily understand and learn from your post dissertation proposal example. I mostly go to the essay writing service for my collage assignments and thesis projects.


    This is an amazing post. I have always been looking for such useful information and I was lucky to find it in your site. spss data analysis help. Thank you for sharing and keep up the good work.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.