RADIUS to RADIUS using Zeroshell

Home Page › Forums › Network Management › Networking › RADIUS to RADIUS using Zeroshell

This topic contains 0 replies, has 0 voices, and was last updated by  matthew.a.squires 10 years, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 21, 2009 at 7:56 pm #41648

    matthew.a.squires
    Member

    Is is possible to to create a wireless connection between two or more Zeroshell Routers using RADIUS?

    A project is coming my way, asking to create a Wireless Network on a small three building Campus.
    I am going to be using three “Hawking Hi-Gain 15dBi Omni-Directional Outdoor Antenna” with a range of up to 1.5 miles per antenna, connected each Netgear WG311T Super-G PCI Card installed in a net5501 Router.

    I want to make sure that the ZS to ZS wireless connection used is a completely different wireless Encryption from the PC Clients.

    This Network will also be supporting VOIP.

    May 6, 2009 at 3:19 pm #48038

    vpn_rollercoaster
    Member

    There’s not enough information in this post to respond directly to your question.

    Basically, as far as best practice for wireless campus connections or building-to-building connections the use of bridging is preferred.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.