proxy arp and cluster question

Home Page Forums Network Management ZeroShell proxy arp and cluster question

This topic contains 0 replies, has 0 voices, and was last updated by  hexa 11 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #40797

    hexa
    Member

    Hello,

    i’m really interested in this project. I was dissapointed with pfsense and ipcop, which are no replacement for my command line configured linux router/cluster firewall.

    My question for you is:
    Do you support proxy arp?
    Do you support active/passive or failover clustered solution (maybe even active/active with ucarp) ?

    If these two conditions are met, i would replace my 5 years old firewalls with nice graphical solution. 🙂

    Even if the two options do not exist, i can help to implement them but we would need to do it really soon.

    #45939

    imported_fulvio
    Participant

    Proxy arp is not supported using the web interface, but you can easilly enable it with the command

    echo 1 > cat /proc/sys/net/ipv4/conf/ETH01/proxy_arp

    which enable the proxy arp on the ETH01 interface.
    Sometimes you used this feature and it worked fine.

    At the moment it is not possible to configure the fault tolerance for the virtual servers.

    Regards
    Fulvio

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.