Problems saving settings

Home Page Forums Network Management ZeroShell Problems saving settings

This topic contains 1 reply, has 0 voices, and was last updated by  mkjtravel 7 years, 2 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #42776

    mkjtravel
    Member

    Hi

    I am new to zeroshell, but got to work after some time and like it very much. But I have problems saving the settings on a USB-stick and running it from CD.

    I did, as described in the FAQ set up a profile in SETUP > Profile and something is saved to the selected stick. I can activate it and the machine reboots. But the only thing that after reboot is set, is the IP-adress, that I defined for the machine. DHCP-settings and NAT-settings are gone.

    What can I have done wrong?

    Juergen

    #51427

    mkjtravel
    Member

    @mkjtravel wrote:

    Hi

    I am new to zeroshell, but got to work after some time and like it very much. But I have problems saving the settings on a USB-stick and running it from CD.

    After installing ZS on harddisk everything works fine.

    Juergen

    #51428

    mlebek
    Member

    I had the same problem with cd-boot.

    solution:
    FIRST you have to create a profile, activate it, reboot, and THEN you setup ips, nat, gateway etc and reboot again.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.