Problem with multiple QOS classifier entries

Home Page Forums Network Management Firewall, Traffic Shaping and Net Balancer Problem with multiple QOS classifier entries

This topic contains 1 reply, has 0 voices, and was last updated by  SilverFalcon 7 years, 5 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #43326

    SilverFalcon
    Member

    We have a zeroshell in place on our network as an internet gateway in routed mode and it works really well. I’ve started looking at using QOS to guarantee bandwidth to a Femtocell on our network. I’ve created two QOS classes and set up the classifier policies as follows:


    QoS Rules
    Seq Input Output Description QoS Class Log Active
    1 ETH00 ETH01 MARK all opt -- in ETH00 out ETH01 10.40.16.16 -> 0.0.0.0/0 MARK set 0xb VOICE no
    2 ETH00 ETH01 MARK all opt -- in ETH00 out ETH01 10.40.16.89 -> 0.0.0.0/0 MARK set 0x10 TEST no

    10.40.16.16 is our femtocell and 10.40.16.89 is a test device.

    However only the first classification rule is being matched and all subsequent traffic is marked on the DEFAULT class.

    When I view the chain I see the following:

    Chain FORWARD (policy ACCEPT 101M packets, 56G bytes)
    pkts bytes target prot opt in out source destination
    294 30725 MARK all -- ETH00 ETH01 10.40.16.16 0.0.0.0/0 MARK set 0xb
    2156 389K ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 MARK match !0x0
    0 0 MARK all -- ETH00 ETH01 10.40.16.89 0.0.0.0/0 MARK set 0x10
    0 0 ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 MARK match !0x0

    Can someone advise if I am doing this wrong, I expected the classifier would continue down the chain if there was no match and then only use the DEFAULT class if there was no match.

    Many thanks in advance!

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.