PPPOE works but eth to modem/router netbalancer always FAULT

Home Page Forums Network Management ZeroShell PPPOE works but eth to modem/router netbalancer always FAULT

This topic contains 1 reply, has 0 voices, and was last updated by  AussieWISP 8 years, 3 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #42825

    AussieWISP
    Member

    I have several adsl lines connected to ZS, one is connected via PPPOE and it works everytime; however if i ever connect a dsl modem/router to eth1 2 or 3 etc and either set static ip or just dynamic ip, netbalancer always goes into FAULT on that connection. Dynamic ip aquires and shows an ip fine but netbalancer always has a problem with it. I have read through many others configs and most set a static ip with the same subnet as the dsl modem/router, i have tried this but alwyas NB goes into fault.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.