PPPOE vlan selection only possible at ETH0 interface

Home Page Forums Network Management ZeroShell PPPOE vlan selection only possible at ETH0 interface

This topic contains 1 reply, has 0 voices, and was last updated by  benb 7 years, 9 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #43081

    benb
    Member

    Hello,
    I build a system to replace my provider router.

    on the ETH0 i have two Vlans

    ETH0.100
    ETH0.101

    On ETH1 (provider) i have 3 vlans

    ETH1.4 (TV multicast)
    ETH1.6 (INTERNET)
    ETH1.7 (Provider VOIP)

    I need to setup two PPPOE connections coming from the same mac

    so i build pppoe0 and pppoe1

    but i am not able to link the ppoe to the interface ETH1.6 and ETH1.7 because this interfaces are not selectable. can only select ETH1

    on the other side i am able to select the ETH0.100 and the ETH0.101

    in the shell i see the interface ETH1.6 and ETH1.7 exist.

    someone know how to do this? if possible
    Regards,
    Ben

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.