Pass through dest ip/port in QOS configuration? Home Page › Forums › Network Management › ZeroShell › Pass through dest ip/port in QOS configuration? This topic contains 0 replies, has 0 voices, and was last updated by grunties 9 years, 5 months ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts October 30, 2009 at 3:51 pm #42006 gruntiesMember Hello, I use ZS as a transparent bridge with QOS and l7 shaping. I have a DMZ network on the outside of the ZS box, and as such, the DMZ is rate limited. Is there a way to make a passthrough destination ip/port where the bridge will forward it, and not inspect in the QOS part of the bridge? I’ve looked all through the forums, and I’m not sure there is a way to do this… Regards, G October 30, 2009 at 5:06 pm #49001 ppaliasMember I don’t think you could exclude this IP:port from the QoS. A workaround would be to create a class containing this IP:port and assign to it the rest of the bandwidth. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.