New to ZeroShell, how to setting it up as router?

Home Page Forums Network Management ZeroShell New to ZeroShell, how to setting it up as router?

This topic contains 2 replies, has 0 voices, and was last updated by  wildbat 12 years, 4 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #40565

    wildbat
    Member

    Hi,
    i am new to ZeroShell ( linux too )
    i wonder how do i setup a linux router with ZeroShell
    I tried the CD ~ but the interface are quite function rich which overwhelmed me.
    can anyone so kind then list out a intructions?

    also ~
    can i setup the network like

    source to internet -> Router -> LAN
    (CABLE + wrieless) ->ZeroShell -> LAN

    #45189

    imported_fulvio
    Participant

    You should read the guide written by Cristian Colombini at the URL
    http://digilander.libero.it/smasherdevourer/schede/linux/zeroshellEN.pdf

    #45190

    wildbat
    Member

    ok i read it but how do i set the ETH01? ip should be automatic assigned.
    btw, i am using cable
    can i combine wireless connection as a source to internet as well ?

    #45191

    imported_fulvio
    Participant

    The current release does not allow to configure (using the web gui) an interface of Zeroshell via dhcp.
    But from the console you could use the command

    dhclient ETH01

    to automatically configure ETH01
    If you want to make this permanent, typr the following command:

    cat “dhclient ETH01” >> /etc/rc.local

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.