Net Balanacer failover monitoring

Home Page Forums Network Management Networking Net Balanacer failover monitoring

This topic contains 2 replies, has 3 voices, and was last updated by  pushing Technology To The Limit 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #63837

    Alex
    Participant

    Hi

    I am running 5 ISP lines on my zeroshell instance, and yesterday we had a weird outage problem where 1 line worked fine on DNS and ping, but couldn’t open any HTTP(s) requests.
    This would make certain clients have long timeout problems and even couldn’t surf at all.

    Is there anyway to do a http request monitoring on lines ?

    #63840

    fulvio
    Keymaster

    Sorry, you cannot do any http check. The failover mechanism is only base on icmp request/reply.

    Regards
    Fulvio

    #65052

    I need some help with my internet.
    My old setup contains five routers. three modems goes into TP link load balance router. IP cop filter router than Netgear SMB router for QOS than my Zedroshell. I am trying to cut every thing down to one Zeroshell. My problem is I connected two of my modems for testing. I only get 6 MB When I do a speed test I need to get 12 MB.I need a simple setup. I need to be able to control the speed on my VLans up and down for my phones, Web TV and computers. My old setup works but takes a lot of time to reboot it all when I have a power failure. I have been doing testing and reading and watching help videos. Thank you for any help.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.