Need help with VLAN setup

Home Page Forums Network Management ZeroShell Need help with VLAN setup

This topic contains 2 replies, has 0 voices, and was last updated by  netsysadmin 9 years, 11 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #41548

    netsysadmin
    Member

    Hi all,

    I want to use ZeroShell to also do inter-VLAN routing. I have created 2 VLANs (VLAN 2 and 3) and assigned IP addresses 10.2.0.1/16 and 10.3.0.1/16 to them, respectively, on ETH01.

    ETH01 is connected to a switch port which has been configured as a trunk (IEEE 802.1Q is enabled on the switch). The switch uplink is also a trunk.

    I configured a PC with IP 10.2.1.34/16 on another switch. The PC is connected to a port on VLAN2 and the uplink of the second switch is also a trunk. However, I cannot ping 10.2.0.1 from the PC, nor can I ping the PC from ZeroShell, despite that the routing table includes the network 10.2.0.0.

    Thanks for any help.

    #47827

    netsysadmin
    Member

    Anyone can help please?

    #47828

    netsysadmin
    Member

    Is there anything wrong in the configuration?

    #47829

    yuda
    Member

    @netsysadmin wrote:

    Hi all,

    I want to use ZeroShell to also do inter-VLAN routing. I have created 2 VLANs (VLAN 2 and 3) and assigned IP addresses 10.2.0.1/16 and 10.3.0.1/16 to them, respectively, on ETH01.

    ETH01 is connected to a switch port which has been configured as a trunk (IEEE 802.1Q is enabled on the switch). The switch uplink is also a trunk.

    I configured a PC with IP 10.2.1.34/16 on another switch. The PC is connected to a port on VLAN2 and the uplink of the second switch is also a trunk. However, I cannot ping 10.2.0.1 from the PC, nor can I ping the PC from ZeroShell, despite that the routing table includes the network 10.2.0.0.

    Thanks for any help.

    Check your switch vlan ID of the vlan 2 and vlan 3
    vlan 2 —>vlan id 2
    vlan 3 —->vlan id 3
    PC connection port must be untag port (access port)
    Ports that switch1 connect to switch2 must be tag port (enable 802.1q)

    u:untag
    t:tag
    2:vlan ID 2
    3:vlan ID 3


    u:2


    t:2,3—-t:2,3—-t:2,3


    t:2,3
    PC


    SWITCH


    SWITCH


    ZEROSHELL

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.