linksys access point Home Page › Forums › Network Management › ZeroShell › linksys access point This topic contains 3 replies, has 0 voices, and was last updated by baboo 11 years, 11 months ago. Viewing 5 posts - 1 through 5 (of 5 total) Author Posts October 17, 2007 at 10:37 pm #40806 babooMember Is it possble to flash a linksys with zeroshell? thanks October 18, 2007 at 5:42 pm #45961 ajl37Member Hi, Could you be a little more detailed with your question? What device are to trying to flash? Andrew October 18, 2007 at 7:12 pm #45962 babooMember thanks for the reply. I haven’t tried to flash anything yet. I have a linksys WRT300N. I was wondering if one could flash it and run zeroshell on the ap. I am willing to try, but have never done this before. I saw a post on net about WRGT ap and how to. Maybe I will just try to follow those steps. But even anyone has done this before and could save me grief by saying yes or no it can be done, would be very appreciated. again thanks for the reply October 18, 2007 at 7:26 pm #45963 imported_fulvioParticipant You should not try to flash Zeroshell on this router because Zeroshell only works on i386 class processor such as Intel Pentium+ and AMD Athlon+ or Geode. Regards Fulvio October 18, 2007 at 10:19 pm #45964 babooMember fulvio: thanks for the reply. Saved me alot of time. thanks again Author Posts Viewing 5 posts - 1 through 5 (of 5 total) You must be logged in to reply to this topic.