Kernel addon Home Page › Forums › Network Management › ZeroShell › Kernel addon This topic contains 2 replies, has 2 voices, and was last updated by Alarmar Colombia 10 months, 2 weeks ago. Viewing 3 posts - 1 through 3 (of 3 total) Author Posts January 6, 2019 at 6:45 pm #64706 Per ChristiansenParticipant So Ive installed 4.14.83 kernel but when I reboot the kernel is not chosen for boot, how can I ensure this? I have no direct access to the machine other than SSH and WebUI. January 6, 2019 at 7:41 pm #64707 Per ChristiansenParticipant Btw. system specs are: Intel(R) Atom(TM) CPU E660 @ 1.30GHz Architecture: i686 CPU op-mode(s): 32-bit, 64-bit Byte Order: Little Endian CPU(s): 2 On-line CPU(s) list: 0,1 Thread(s) per core: 2 Core(s) per socket: 1 Socket(s): 1 Vendor ID: GenuineIntel CPU family: 6 Model: 38 Stepping: 1 CPU MHz: 1299.960 BogoMIPS: 2599.92 Virtualization: VT-x L1d cache: 24K L1i cache: 32K L2 cache: 512K NICS: ETH00 1000Mb/s Full Duplex Intel Corporation Platform Controller Hub EG20T Gigabit Ethernet Controller (rev 02) UP 172.16.0.1 255.255.255.0 VLAN: 1 (Default) 172.16.1.1 255.255.255.0 VLAN: 2 (IOT) 172.16.3.1 255.255.255.0 Dynamic IP: 0.0.0.0 MAC: 001B1B0837A5 ETH01 1000Mb/s Full Duplex Intel Corporation I210 Gigabit Network Connection (rev 03) UP Dynamic IP: xxx.xxx.xxx.xxx (hidden) MAC: 6805CA8B64AC ETH02 100Mb/s Full Duplex Intel Corporation 82574L Gigabit Network Connection UP VLAN: 3 (Kids) 172.16.2.1 255.255.255.0 Dynamic IP: 0.0.0.0 MAC: 001B1B0A049D VPN99 Connections from Road Warrior clients disabled Host-to-LAN OpenVPN Interface UP 192.168.250.254 255.255.255.0 MAC: 4EC4FFA36C3A January 8, 2019 at 4:50 pm #64716 Alarmar ColombiaParticipant Hello! You have to select the kernel In the Setup Section, Boot Button (top right), SLOT 1. Mauricio Author Posts Viewing 3 posts - 1 through 3 (of 3 total) You must be logged in to reply to this topic.