Installation issues – NIC

Home Page Forums Network Management ZeroShell Installation issues – NIC

This topic contains 1 reply, has 0 voices, and was last updated by  SpeedD408 8 years, 9 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #42774

    SpeedD408
    Member

    Hello,

    I purchased and Apoen DE2700 – Atom N270, 2x Gig NIC (Realtek), 1 Gig RAM. I wont go into to much detail about the box because beta 13 seems to load just fine. The NIC’s are seen and the software loads just fine (currently have a USB keyboard and monitor hooked up to it). However, I don’t get a link state on the Ethernet ports. The lights go on showing the hardware sees link, but the software doesn’t and I can’t web into the box to configure it (time out). I tried monowall just to see and that did the same thing so I loaded Kubuntu 10.10 to see if it was a hardware issue or something else. Kubuntu loads via the same 2Gig CF card as Zeroshell and is able to see both interfaces. If I put IP address on them, I can ping in and out just fine.

    Is there something in the FW section I can change from the console that would allow me to test it.

    Any other thoughts?

    Thanks,
    John.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.