force full duplex Home Page › Forums › Network Management › Networking › force full duplex This topic contains 2 replies, has 0 voices, and was last updated by hilldweller 3 years, 10 months ago. Viewing 4 posts - 1 through 4 (of 4 total) Author Posts June 14, 2007 at 10:31 am #40647 hilldwellerMember hi, one of my ethernet cards is connected to a transmitter which is not capable of auto-detection for speed and always defaults to half duplex. it is full duplex capable, is there a way i can force the card to be full duplex on zeroshell? thanks john June 16, 2007 at 2:40 pm #45443 imported_fulvioParticipant You cold try with ethtool -s ETH00 duplex full June 18, 2007 at 7:40 am #45444 hilldwellerMember thanks fulvio i’ll give that a go… and i presume echo “ethtool -s ETH00 duplex full” >> /etc/rc.local would get it to go on startup. 🙂 October 31, 2015 at 4:06 am #45445 janmoysMember when I execute this one. I get some error: Cannot advertise duplex full Author Posts Viewing 4 posts - 1 through 4 (of 4 total) You must be logged in to reply to this topic.