Failure firewall rules Home Page › Forums › Network Management › Networking › Failure firewall rules This topic contains 1 reply, has 0 voices, and was last updated by Delio 11 years, 11 months ago. Viewing 1 post (of 1 total) Author Posts November 6, 2007 at 10:34 pm #40823 DelioMember I did tests with firewall ZeroShell. Rules in INPUT e OUTPUT is not functionaly. Only chain FORWARD. Example: There are 2 ethernet interfaces ETH00 and ETH01 = BRIDGE00 Rule CHAIN: INPUT (Not functionaly) Interface input ETH00 DROP ALL Destination 10.10.10.2 Rule CHAIN: OUTPUT (Not functionaly) Interface output ETH01 DROP ALL Destination 10.10.10.2 Rule CHAIN: FORWARD (Functionaly) Interface input (all – blank) Interface output ETH01 DROP ALL Destination 10.10.10.2 My rules is incorret or error in ZeroShell? If my rules is incorret, because rules chain INPUT or OUTPUT is not functionaly? Tank you Author Posts Viewing 1 post (of 1 total) You must be logged in to reply to this topic.