Failover on LAN with DHCP and NAT

Home Page Forums Network Management Networking Failover on LAN with DHCP and NAT

This topic contains 0 replies, has 0 voices, and was last updated by  JeroenSt 7 years, 8 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #43225

    JeroenSt
    Member

    Hello,

    I would like to create the following:

    ETH01 and ETH03 are NAT enabled and getting there IP by DHCP. I tried different configurations, but none seems to work..

    Can somebody help me?

    The idea is that when ETH01 goes down ETH03 takes over.

    #52119

    Alderon
    Participant

    The best way to back-up ethernet connection to ISP router is creating bridge from ETH1, ETH3 and enabling NAT on it. Don`t forget enable STP on bridge interface to avoid switching loops. STP will provide failover.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.