Doubts about STA mode Home Page › Forums › Network Management › Wireless Networks › Doubts about STA mode This topic contains 0 replies, has 0 voices, and was last updated by bluehand 8 years, 11 months ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts March 16, 2010 at 10:52 pm #42285 bluehandMember Hello to all, this is my first post here! I recently configured a zeroshell machine (it has been a hard work :oops:, i have almost no linux knownledge), with a wifi atheros card, i put it in STA mode connected to an existing AP. What the “Associated Station” means? ETH02 AP:001A6C3C48C1 Freq: Current Frequency=2.462 GHz (Channel 11) Rate:1Mb/s Quality:11/70 WiFi - [SSID:in-cec] [Mode:sta] [Security:wpa-psk] VLAN: none 11: ETH02: mtu 1500 qdisc noqueue inet 172.17.45.73/23 brd 172.17.45.255 RX: bytes packets errors dropped overrun mcast 7900840 17058 0 0 0 0 TX: bytes packets errors dropped carrier collsns 1004544 6475 72 72 0 0 Throughput: RX 3.25 Kbit/s TX 0 bit/s ETH02 IEEE 802.11g ESSID:"in-cec" Nickname:"" Mode:Managed Frequency:2.462 GHz Access Point: 00:1A:6C:3C:48:C1 Bit Rate:1 Mb/s Tx-Power=18 dBm Sensitivity=1/1 Retry:off RTS thr:off Fragment thr:off Encryption key:asfd-asdf-asdf-asdf-asdf-aasd-asdf-asdf Security mode:restricted Power Management:off Link Quality=11/70 Signal level=-83 dBm Noise level=-94 dBm Rx invalid nwid:95169 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 Stations: 1 Associated Station Rate 00:1a:6c:3c:48:c1 1M March 17, 2010 at 7:20 am #49901 ppaliasMember It is the MAC address of the Access Point you are connected to. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.