Configuring zeroshell as a router in vmware

Home Page Forums Network Management Networking Configuring zeroshell as a router in vmware

This topic contains 1 reply, has 0 voices, and was last updated by  HiTekRedNek 10 years, 11 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #40897

    HiTekRedNek
    Member

    Hi, This is a complete N00bie question. I have had very limited experience in Linux and I am just so so in routing knowledge. What I am looking for is either help or a link to a tutorial about a specific VMWARE tutorial.
    I am looking to use zeroshell to route between my 2 LAN segments that I have configured under a VMWARE workstation team. I am building a multi site AD/DNS infrustructure simulation and would like to have the ability to be able to also see the outside world because I want to setup DNS forwarding through at least one of the sites. I may also want to configure a WSUS server to grab updates. Ideally I would like to isolate my virtual LAN’s from the physical.

    My network summary
    Physical LAN = 192.168.2.0/24 def g/w 192.168.2.1
    LAN A = 192.168.149.0/24 (VMNET3)
    LAN B = 192.168.96.0/24 (VMNET4)

    Much thanks to anybody who can provide some assistance.[/b]

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.