Compatibility betwen Captive Portal and QoS

Home Page Forums Network Management ZeroShell Compatibility betwen Captive Portal and QoS

This topic contains 2 replies, has 0 voices, and was last updated by  josean_rt 9 years, 8 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #41702

    josean_rt
    Member

    Hi!!
    I have Captive Portal configured in ETH02 (10.0.0.X) interface mode ROUTED , my Gateway is ETH00 192.168.1.X, and now i would like to configure a QoS. If i make an a bridge betwen ETH00 and ETH02 for QoS, the captive portal is now in ETH00 (192.168.1.X) and every times when i wont to manage zeroshell I must login first in the captive portal and later in the zeroshell manage portal.

    Please. How can I solve? I read something about the routed o bridged problem with Captive Portal but i canĀ“t solve

    Thanks a lot!

    #48178

    giancagianca
    Member

    Enter mac address in authorized services of captive portal. You can bypass captive portal login.

    Bye

    #48179

    josean_rt
    Member

    Thanks for youre quick answer!!

    but i think there is another posible solution, like before to turn on the QoS.
    I usually conect from ETH00 to manage the zerosshell and EtH02 for the Captive Portal but now with the bridge in both interfaces apera the captive portal

    #48180

    giancagianca
    Member

    If you select bridge as mode of captive portal a select eth02 only eth02 are captured.

    Bye

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.