Captive protal not working

Home Page Forums Network Management ZeroShell Captive protal not working

This topic contains 3 replies, has 0 voices, and was last updated by  on 8 years, 2 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #42994

    on
    Member

    Hi,

    I am new to Zeroshell, even though I have a long experience on Unixes.

    I have set a box with 3 interfaces. Eth0 and Eth1 are bridged, no IP; Eth2 is the management interface, for web configuration.

    Eth1 is the inside interface (1 like i, like inside; 0 like o, like outside); bridge is working fine: a client inside can access a web server outside.

    Problem arise when I try to launch captive portal. I have set it to interface Eth1 and bridged mode. But the client inside cannot access anything and does not get the authentication screen. Rest is pretty much default except I am using my own X509 key/certificate/ca.

    Help will be greatly appreciated.

    Olivier

    #51766

    _dan
    Member

    Sorry I’m a beginner here(ZS) however I manage to make it to work, same situation here 0 for WAN 1 LAN .
    1. check your logs(RADIUS,Kerberos, DHCP)
    2. Post the output for

    route

    Let’s start from here.

    Regards,

    #51767

    giancagianca
    Member

    You must assign ip to brigde to run captive portal.

    Bye.

    #51768

    on
    Member

    Thanks, in fact I am one step further.

    The bridge DO NEED an IP address to display the authentication page. So I am there now.

    I have to find how to authenticate to my existing Radius.

    Olivier

    #51769

    on
    Member

    @giancagianca wrote:

    You must assign ip to brigde to run captive portal.

    Bye.

    Thanks, I found out the hard way 🙂

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.