Bridging 2 LANs [Solved]

Home Page › Forums › Network Management › Bridges and Routers › Bridging 2 LANs [Solved]

This topic contains 0 replies, has 0 voices, and was last updated by  Lightyear 5 years, 11 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • January 7, 2013 at 10:49 pm #43539

    Lightyear
    Member

    Greetings. I’m currently using ZS 2.0 RC1, and my setup is as follows:


    
ETH00           ETH02
    
           /
    
         /
    
ZeroShell
    
/         
    
/           
    
ADSL             3G

    ADSL and 3G work in failover mode; ADSL is usually active and 3G spare.
    ETH00 is configured as 10.1.1.254/24; ETH02 as 10.2.2.254/24
    I want to bridge ETH00 and ETH02, to use only BRIDGE00 as 10.1.1.254/24.
    However, when I try to add ETH00 to the bridge (via console) the web interface dissapears (as one would expect) but doesn’t return.
    ZeroShell appears to work as usual: both ssh access to ZeroShell and http internet access are unchanged, and I can access from LAN1 (ETH00) the web interface of a Linksys router in LAN2 (ETH02) as always.
    The only thing that doesn’t work is ZeroShell web interface.

    Any idea is welcome.

    January 10, 2013 at 12:38 am #52597

    Lightyear
    Member

    Restarting did the trick. When Zeroshell came back, all was fine.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.