Bridge is lost on reboot

Home Page Forums Network Management ZeroShell Bridge is lost on reboot

This topic contains 1 reply, has 0 voices, and was last updated by  Pisys.Net 5 years, 4 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #43704

    Pisys.Net
    Member

    Hi

    I have a network bridge created between two NICs, and firewall rules applied to them.

    Even though I have saved the profile and everything else comes back, the Bridge itself is lost, and the IP address assigned falls back to one of the NICs.
    When I save a profile however, you have to enter network information and choose a network adaptor – I cannot choose the Bridge adaptor from here, only eth00 and eth01.

    is there a workaround for this? Unfortunately this means if the machine is reboot due to power failure or any other reason, we have to manually add the bridge back in to get internet access again.

    Thanks
    Ben

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.