BRIDGE getting wrong IP. Home Page › Forums › Network Management › ZeroShell › BRIDGE getting wrong IP. This topic contains 4 replies, has 0 voices, and was last updated by lelemm 9 years, 6 months ago. Viewing 6 posts - 1 through 6 (of 6 total) Author Posts December 8, 2009 at 3:30 am #42087 lelemmMember Scenario: LAN – ETH00 WAN – ETH01 – ISP network (cable modem: set ip, gateway and dnv via dhcp) BRIDGE00 with both ethernets. NAT for BRIDGE00 DHCP server for BRIDGE00 (Network 192.168.3.0/255.255.255.0) The problem is: when i boot zeroshell, the bridge gets a LAN IP. (like 192.168.3.100) not the ISP ip, how can i fix it? Thank you! December 8, 2009 at 3:50 am #49232 lelemmMember if i dhclient BRIDGE00 -s XXX.XXX.XXX.XXX it works, but, if the server change the IP, what should i do? December 8, 2009 at 4:06 am #49233 ppaliasMember What you are trying to do is wrong! You shouldn’t bridge the ISP network with your internal network. Leave the BRIDGE out and use routing mode. December 8, 2009 at 4:10 am #49234 lelemmMember @ppalias wrote: What you are trying to do is wrong! You shouldn’t bridge the ISP network with your internal network. Leave the BRIDGE out and use routing mode. but i want to use downstream qos, and i just did it work with the bridge mode. any way do work with routing mode? December 8, 2009 at 4:17 am #49235 ppaliasMember QoS works fine with routing mode as well. Just apply the policy on the outgoing WAN interface. December 8, 2009 at 4:33 am #49236 lelemmMember yeah, for some reason now its working on my router mode profile 😆 Author Posts Viewing 6 posts - 1 through 6 (of 6 total) You must be logged in to reply to this topic.