Bridge Configuration

Home Page Forums Network Management Networking Bridge Configuration

This topic contains 3 replies, has 0 voices, and was last updated by  tashi 9 years, 10 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #41870

    tashi
    Member

    Hi all

    I try to create a bridge between two networks. I addes both interfaces, but the traffic was not routed between the two networks. Do I miss something?

    #48651

    ppalias
    Member

    You bridge interfaces, not networks. When you bridge 2 networks they are in the same collision domain, which means you have to have a single subnet.

    #48652

    tashi
    Member

    Ok then I`m on the wrong way. I just like to configure routing between two networks. How can I configure that? If someone point me to rtfm, i would appreciate a link.

    Here is the Routing table. All automatically created, after I configured the Interfaces. The routing should be between the networks 10.1.1.0 and 192.168.222.0


    Destination Netmask Type MetricGateway Interface Flags State Source
    192.168.250.0 255.255.255.0 Net 0 none VPN99 U Up Auto
    10.1.1.0 255.255.255.0 Net 0 none ETH00 U Up Auto
    192.168.222.0 255.255.255.0 Net 0 none ETH01 U Up Auto
    DEFAULT GATEWAY 0.0.0.0 Net 0 10.1.1.1 ETH00 UG Up Static
    #48653

    ppalias
    Member

    Unless you have blocked something on the firewall, routing works by the time you configure the IP/MASK on the interfaces. Just assign the Zeroshell IP as a gateway for the PCs connected on each interface and it should work.

    #48654

    tashi
    Member

    Thank you for your hint. I configured the Client with the Zeroshell as Gateway. But I does`nt work. Now I see, the config tool where I configured the Gateway doesn`t work well. When I done the route command, there was no gateway listed.
    I add the Gateway now manually. And it works.

    Thank you for your help.

    tashi

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.