accessing dsl modem Home Page › Forums › Network Management › Networking › accessing dsl modem This topic contains 0 replies, has 0 voices, and was last updated by vitesse 8 years, 5 months ago. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts September 27, 2010 at 9:02 pm #42659 vitesseMember I want to have access to my dsl modems that are physically connected to eth01 and eth02. they are both used to connected to Internet in mlppp mode from ppp0. I need it to use dmt tool (telnet access) so I can get line stat. Was using a simple tomato/mlppp setup on a linksys wrt54gl before and it was easy. Now I have no clue on zeroshell. I would like to use a local IP to access it on the lan. Currently 192.168.1.10 -> ETH00 (lan switch) would like 192.168.1.1 first st516 dsl modem 192.168.1.2 second st516 dsl modem but I have no clue if it’s possible to have both modem on the same subnet as my network. Thanks for your help 🙂 September 28, 2010 at 6:47 am #51121 ppaliasMember One solution I have come across is to assign your modems to different subnets and NAT on the interfaces that connect to them. Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.