Home Page › Forums › Network Management › Networking › ZS – default GW routing is not initialized @ boot/power up › Re: ZS – default GW routing is not initialized @ boot/power up
April 27, 2011 at 1:01 pm
#51709

Participant
@aemarx wrote:
im not sure if this help you. I set my default gateway at
SYSTEM > Setup > Network > Gateway(button) .
Thanks. Your method does work.
However, I was expecting that a definition of a “static route” entry under
NETWORK > Router > Default GW also to be brought “up” at boot time.
Another method that works for me:
In the definition of a new “profile”, enter an IP number in the “GW” field. It must be on the same subnet of the interface. Later it can changed to route through any other interface.
— Arun Khan