Re: Re: Need help with VLAN setup

Home Page Forums Network Management ZeroShell Need help with VLAN setup Re: Re: Need help with VLAN setup

#47829

yuda
Member

@netsysadmin wrote:

Hi all,

I want to use ZeroShell to also do inter-VLAN routing. I have created 2 VLANs (VLAN 2 and 3) and assigned IP addresses 10.2.0.1/16 and 10.3.0.1/16 to them, respectively, on ETH01.

ETH01 is connected to a switch port which has been configured as a trunk (IEEE 802.1Q is enabled on the switch). The switch uplink is also a trunk.

I configured a PC with IP 10.2.1.34/16 on another switch. The PC is connected to a port on VLAN2 and the uplink of the second switch is also a trunk. However, I cannot ping 10.2.0.1 from the PC, nor can I ping the PC from ZeroShell, despite that the routing table includes the network 10.2.0.0.

Thanks for any help.

Check your switch vlan ID of the vlan 2 and vlan 3
vlan 2 —>vlan id 2
vlan 3 —->vlan id 3
PC connection port must be untag port (access port)
Ports that switch1 connect to switch2 must be tag port (enable 802.1q)

u:untag
t:tag
2:vlan ID 2
3:vlan ID 3


u:2


t:2,3—-t:2,3—-t:2,3


t:2,3
PC


SWITCH


SWITCH


ZEROSHELL