Re: Re: can some one help me with virtual servers

Home Page Forums Network Management ZeroShell can some one help me with virtual servers Re: Re: can some one help me with virtual servers

#46196

If you point your browswer at http://192.168.0.1:8080 does that redirect you to your webserver?

@charliechaklam wrote:

hi,

i have ppoe connected to interface eth00 and switch conected to eth02 and i am hosting a page on 192.168.0.92 on port 80 in the internal network with is on eth02. so i went in vir. serv. and configure 8080 to go to 192.168.0.92:80 but it does not work , i cant figure it out i have given up so some assistace would be golden, below is the network info.

Nat view
Chain PREROUTING (policy ACCEPT 13043 packets, 723K bytes)
pkts bytes target prot opt in out source destination
0 0 DNAT tcp — ppp0 * 0.0.0.0/0 0.0.0.0/0 tcp dpt:8080 to:192.168.0.92:80
0 0 DNAT tcp — ETH02 * 0.0.0.0/0 0.0.0.0/0 tcp dpt:8080 to:192.168.0.92:80

Chain POSTROUTING (policy ACCEPT 767 packets, 95694 bytes)
pkts bytes target prot opt in out source destination
12967 745K SNATVS all — * * 0.0.0.0/0 0.0.0.0/0
12200 650K MASQUERADE all — * ppp0 0.0.0.0/0 0.0.0.0/0

Chain SNATVS (1 references)
pkts bytes target prot opt in out source destination

Info from network page
PPP0 Connected inet addr:64.86.xxx.112 P-t-P:206.xxx.48.10 (Modem: ETH00)
Velcom Internet

ETH02 100Mb/s Full Duplex
Intel Corporation 82557/8/9 Ethernet Pro 100 (rev 02) UP

192.168.0.1 255.255.255.0

Thank you