Home Page › Forums › Network Management › ZeroShell › How to not forward default gateway over openvpn on road warr › Re: I just want this kind of user interface.
I am sorry I need to reconfigure ZeroShell to reply your answer!
I just hope something like below to be added in the ZeroShell. It was taken from one of the administrator screen in NETGEAR SSL312 VPN gateway. It’s user interface is very easy to understand.
VPN Tunnel Client
Client IP Address Range
Client Address Range Begin : 192.168.100.1
Client Address Range End : 192.168.100.253
Enable Full Tunnel Support : [ ]
Note: Static routes should be added to reach any secure network in split tunnel mode.
Add Routes for VPN Tunnel Clients
Destination Network : [_______________]
Subnet Mask : [_______________]
[Add Route] [Cancel]
Configured Client Routes
Destination Network Subnet Mask
xxx.xxx.xxx.0 255.255.255.0 [Delete]