Re: equipment conectivity using tera term – reply

Home Page Forums Network Management ZeroShell equipment conectivity using tera term Re: equipment conectivity using tera term – reply

#52548

lennynpeter
Member

Thanks for your post. The Cisco switch has IP 10.95.90.150,
network mask is 255.255.255.0 and the default gateway 10.95.90.254
connected to ETH00 with IP 10.95.90.254, network mask 255.255.255.0,
about the default gateway I’m not completely sure in the case of ETH00
so I’ve added below the zeroshell routing table:

Destination Netmask Gateway Interface
DEFAULT GATEWAY 0.0.0.0 10.64.64.64 ppp0
10.64.64.64 255.255.255.255 none ppp0
10.95.90.0 255.255.255.0 none BRIDGE00
10.95.91.0 255.255.255.0 none BRIDGE00
10.95.98.0 255.255.255.0 none BRIDGE01

Hope that helps so far!

Peter