Home Page › Forums › Network Management › ZeroShell › QOS and VoIP › Re: Configuring QOS for VOIP
Hoping someone can point me in the right direction about configuring QOS for the Linksys PAP2T adapter I am using.
I’ve added a VOIP class, classified it for SIP protocol, attached VOIP class to PPPOE interface and saved/activated everything. However there are no VOIP class packets in the Statistics window even as I am talking over the phone attached to the PAP2T.
My class definition is as follows:
1 * * MARK all opt — in * out * 0.0.0.0/0 -> 0.0.0.0/0 LAYER7 l7proto sip MARK set 0xd
PPPOE interface reads this status:
QoS Status:Enabled Max:5Mbit/s Guaranteed:5Mbit/s (Assigned:2%)
Tried to move VOIP class to ETH1 to which PPP is attached, to no avail.
What am I doing wrong?