Reply To: Zeroshell as a Captive Portal for IOS devices

Forums Network Management RADIUS 802.1x and Captive Portal Zeroshell as a Captive Portal for IOS devices Reply To: Zeroshell as a Captive Portal for IOS devices

#66401

I’ve read all through the forums and cant seem to find a solution to this. I see a lot of posts with people experiencing the same issues. Has anyone had success in getting the Captive Portal to load automatically upon connecting wirelessly? It works flawlessly with Android, however, with iOS it connects with no other indication that you are behind a captive portal. You have to open safari, then a new tab and type in an address or the address of the zeroshell router.

Any advice even for dummmies is appreciated as this is the only thing holding me back from going live with my setup. I’ve been researching this for a little over a week.

Rundown on my setup…
Eth0 – 10.1.0.0/24, Captive portal active on this interface. Public Wifi with AP directly connected
Eth1 – 192.168.1.0/24, Internal Private network both wired and wireless.
Eth2 – 192.168.100.0/24, WAN Interface Direct connect to modem which is preset with 192.168.100.1. NAT enabled

Routing Table…
DEFAULT GATEWAY 0.0.0.0 Net 0 ###.##.40.1 ETH02 UG Up Static
DEFAULT GATEWAY 0.0.0.0 Net 0 192.168.1.1 ETH01 UG Up Static
10.1.0.0 255.255.255.0 Net 0 none ETH00 U Up Auto
10.1.0.0 255.255.255.0 Net 1 192.168.1.1 ETH01 UG Up Static
174.53.40.0 255.255.252.0 Net 0 none ETH02 U Up Auto
192.168.1.0 255.255.255.0 Net 0 none ETH01 U Up Auto
192.168.100.0 255.255.255.0 Net 0 none ETH02 U Up Auto
192.168.100.0 255.255.255.0 Net 1 192.168.1.1 ETH01 UG Up Static
192.168.250.0 255.255.255.0 Net 0 none VPN99 U Up Auto

Thank you in advance to anyone who may have a better insight into this!