Reply To: [Help] configuring Net Balancer

Home Page Forums Network Management ZeroShell [Help] configuring Net Balancer Reply To: [Help] configuring Net Balancer

#51902

AussieWISP
Member

If I hear you right, NB just needs a new gateway setup for each gateway, so if the ip of router one was 192.168.0.1, then gateway one would be 192.168.0.1. This would be done four times for each gateway, if you leave all other setting as they are you should be fine. However you will also need to setup failover if you need it. Don’t forget to setup NAT under Router for that ETH port.