Home Page › Forums › Network Management › ZeroShell › Outbound NAT to a specific IP › Reply To: Outbound NAT to a specific IP
Yes, I almost forgot in the beginning need to add IP address on an interface.
ETH00 1000Mb/s Full Duplex
Realtek Semiconductor Co., Ltd. RTL-8169 Gigabit Ethernet (rev 10) UP
VLAN: 771 (Inet_1)
9.9.9.1 255.255.255.0
9.9.9.2 255.255.255.0
9.9.9.3 255.255.255.0
In (Net Balancer) to prescribe rules for the Local IP and send them to the appropriate interface.
* * MARK all opt — in * out * 10.55.0.62 -> 0.0.0.0/0 MARK set 0x68 Inet_1 (9.9.9.254)
* * MARK all opt — in * out * 10.55.0.57 -> 0.0.0.0/0 MARK set 0x68 Inet_1 (9.9.9.254)
* * MARK all opt — in * out * 10.55.0.172 -> 0.0.0.0/0 MARK set 0x68 Inet_1 (9.9.9.254)