Reply To: Zeroshell and Cisco router

Home Page Forums Network Management ZeroShell Zeroshell and Cisco router Reply To: Zeroshell and Cisco router

#51407

impeesa
Member

Unfortunately I can’t access to router, cause the router set by admin at center office.

If I change gateway client 192.168.2.51 with 192.168.2.10, I can ping to segment 10.10.10.0/24 and segment 192.168.2.0/24 and I can ping too from 10.10.10.0/24 to 192.168.2.0/24

right now all client gateway segment 192.168.2.0/24 default to 192.168.2.51 and can ping to segment 10.10.10.0/24 without change IP gateway, Can I?

before, I configure zeroshell with:
ETH00 = 192.162.2.10
ETH01 = 10.10.10.10
Default Gateway = 192.168.2.51

I want to make connection between two LAN with different segment (192.168.2.0/24 and 10.10.10.0/24), so in zeroshell I set ETH00 and ETH01 to NAT. That’s it

am I right? or is there another way or the best advice for configuration zeroshell with that case? cause I’m new in zeroshell. Thx