Reply To: Cannot access subnet except through ZS command line

Home Page Forums Network Management Networking Cannot access subnet except through ZS command line Reply To: Cannot access subnet except through ZS command line

#51036

ppalias
Member

Most likely you are NATing traffic going out of ETH00 interface. This means that all traffic coming from ETH01 interface has its source IP translated into the IP of ZS (192.168.1.3). In order to make it work from outside to inside you have to do 2 things:
1) Add a static route on the router outside for the network 192.168.2.0/24 that is reachable via 192.168.1.3
2) Remove NAT completely or configure it not to masquerade when the destination address is 192.168.0.0/16