Reply To: Firewall question

#50834

Luigi10
Member

Here is a diagram of our topology:

Here is a screenshot of the Virtual Server config:

Here is a screenshot of our Balance Rules:

All traffic with port 80 or 443 goes out the Cable connection. Then we have all traffic for the server going out our WAN connection. Then we have all other traffic from the workstations go out the Cable connection.

ETH00 is the LAN Adapter. IP address 10.49.1.1.
ETH01 is the Cable Adapter. IP Address id Dynamic.
ETH02 is the WAN Adapter to our Network. IP Address is 10.104.117.2.

We currently have no Firewall rules in place. It is just set to the default which is enabled but no rules specified. Would you like to me to configure the firewall rules and make a screenshot of that also?