Reply To: vpn lan to lan bond lossing packages

Home Page Forums Network Management VPN vpn lan to lan bond lossing packages Reply To: vpn lan to lan bond lossing packages

#50819

ciprianc
Member

Thank you so much for reply,

I see your reply and get back to it as soon as possible,

All my config is done trough web interface(I don’t know what are other options in configuring this)

I was using the profiles from zeroshell, to set up a test network using a vmware workstation appliances and have the same problem that I was talking about.

Here is my setup:

			                            :(192.168.1.30)eth00 -- :(192.168.1.3)R01(192.168.50.31):

(side1)LAN1--eth02(10.10.10.31): ZS1 .BOND00(192.168.200.1) 192.168.50.0/24

:(192.168.2.30)eth01 -- :(192.168.2.3)R02(192.168.50.32):


:(192.168.50.33)R03(192.168.3.3): -- eth00(192.168.3.33):

192.168.50.0/24 BOND00(192.168.200.2). ZS2 :eth02(10.10.11.33) -- LAN2(side2)

:(192.168.50.34)R04(192.168.4.3): -- eth01(192.168.4.30):

the “–” are Ethernet connections and “:” are network interfaces

in my test env. the routers R01, R02, R03, R04 are Zeroshell installations with interfaces numbered as above and NAT enabled on the 192.168.50.0/24 network, and port forward to eth00 and eth01 respectively on both sides for VPN purpose.

side1

VPN00:
gateway: 192.168.50.33
mode:server
transport: udp
authentication: pskey

VPN01:
gateway: 192.168.50.34
mode:server
transport: udp
authentication: pskey

side2

VPN00:
gateway: 192.168.50.31
mode:client
transport: udp
authentication: pskey

VPN01:
gateway: 192.168.50.32
mode:client
transport: udp
authentication: pskey

I have NAT enable on ZS1 and ZS2 for eth00 and eth01 on both sides

The only static routes are 10.10.11.0/24 gw 192.168.200.2 on ZS1 and
10.10.10.0/24 gw 192.168.200.1 on ZS2.

The ZS1’s and ZS2’s netbalancer and BOND00 are configured for failover

As I described the problem is loosing packages when ping from 10.10.10.100 in LAN2 the 10.10.10.31 on ZS1

I think this is a simple setup, yet I don’t manage to get pass this problem, even after trying different configurations options

Thank you for any help in this