Home Page › Forums › Network Management › ZeroShell › High Latency Using HTTP PRoXY – ZeroShell Bridge › Reply To: High Latency Using HTTP PRoXY – ZeroShell Bridge
June 29, 2010 at 11:04 pm
#50573
Member
You can verify it with running the command
iptables -L -v
iptables -t nat -L -v
If there is a rule only for port 80 requests then it captures only HTTP. Most likely adding the same rules for port 443 as well would fix it, but I’m not sure if it would cause a problem on the web interface of ZS.