Reply To: Net Balancer

Home Page Forums Network Management Networking Net Balancer Reply To: Net Balancer

#50383

Luigi10
Member

We are trying to setup load balancing between a DSL connection and a Cable connection. Whenever We have the failover monitor in place, the DSL connection fails. In the routing table, the default gateway shows that all traffic should be going out the connection for the DSL connection, but when I try to run a trace route or ping a public IP address it doesn’t work.

Traffic is getting stopped at the WAN Port on the Zero Shell server for the DSL connection.

If I were to ping a device that is past the WAN Port for the DSL connection, it is successful. I don’t know what the problem is. I can provide tracerts and IP addressing if you need.

Thanks for your time.